C20EA BMW Fault Code

Description:

Output Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.

C20EA Code Symptoms :

While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the C20EA code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.

Diagnosis And Repairing C20EA

C20EA the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.

How to fix C20EA code ?

• EVAP system hose leaking
• Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
• Ignition misfiring
• Exhaust gas leaks

Regardless of the design though, the purpose of all clutch actuating systems is to improve the driving experience by removing the need for manual clutch operation by the driver.

Computer-controlled clutch actuating systems work particularly well in dual clutch systems where one clutch controls gear changes of even-numbered gear ratios, and a second clutch that controls gear changes of odd-numbered ratios.